Add log message to send_signal().

[dss.git] / dss.suite

diff --git a/dss.suite b/dss.suite
index e69cc28630c8a39359cba3aead33ab3b847011a8..95dd30ff9dc7ea5963957aad8e809a57d0277c52 100644 (file)
--- a/dss.suite
+++ b/dss.suite
@@ -34,7 +34,7 @@ caption = Subcommands
                        However, there is one exception to this rule: The run subcommand
                        re-reads the configuration file when it receives the HUP signal. In
                        this case the options in the config file override any options that
                        However, there is one exception to this rule: The run subcommand
                        re-reads the configuration file when it receives the HUP signal. In
                        this case the options in the config file override any options that

-                       were previously given at the command line. This allows to change the
+                       were previously given at the command line. This allows changing the

                        configuration of a running dss process by sending SIGHUP.
                [/help]
        [option loglevel]
                        configuration of a running dss process by sending SIGHUP.
                [/help]
        [option loglevel]


@@ -312,8 +312,8 @@ caption = Subcommands
                typestr = percent
                default_val = 2
                [help]
                typestr = percent
                default_val = 2
                [help]

-                       This is like --min-free-mb but allows to specify the amount of
-                       free disk space as a percentage. It is not recommended to set both
+                       This is like --min-free-mb but the amount of free disk space
+                       is specified as a percentage. It is not recommended to set both

                        --min-free-mb and --min-free-percent to zero as this will cause your
                        file system to fill up quickly.
                [/help]
                        --min-free-mb and --min-free-percent to zero as this will cause your
                        file system to fill up quickly.
                [/help]


@@ -475,6 +475,14 @@ caption = Subcommands
 
                        Sending SIGHUP causes the running dss process to reload its config file.
                [/help]
 
                        Sending SIGHUP causes the running dss process to reload its config file.
                [/help]

+[subcommand configtest]
+       purpose = run a configuration file syntax test
+       [description]
+               This command checks the command line options and the configuration
+               file for syntactic correctness. It either reports "Syntax Ok" and
+               exits successfully or prints information about the first syntax error
+               detected and terminates with exit code 1.
+       [/description]

 
 [section copyright]
        Written by Andre Noll
 
 [section copyright]
        Written by Andre Noll